Add a Weiser lock to a SmartThings Hub

Add a Weiser lock to a SmartThings Hub

Steps to add a Weiser lock to a SmartThings Hub:

  1. I factory reset the lock by following the manufacturer’s instructions:

  • Remove the battery pack from the lock

  • Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the status LED flashes red.

  • Press the Program button once more. When the LED flashes green, the lock has been reset.

  • Re-calibrate the lock and program your PIN

 

  1. Pair with SmartThings [found information on how to put the lock into pairing mode by following: 

  • Open the SmartThings app and “Add new thing”

  • While it is searching for things press the “A” button on the lock four (4) times until the LED blinks Red/Amber.

  • Note: I had to perform the “Press A four times” sequence a few times for the lock to finally appear in the SmartThings App as a “Kwikset Lock”.

  • Note: The lock appears in the SmartThings as a “Kwikset Lock”

  • Proceed as you would when adding any other device to SmartThings