Factory Reset Insteon Switches
Pull the set button out completely, let it stay out for 10 seconds.
Push it back in PAST THE NORMAL POINT, all the way in and hold it for about 5 seconds or so until you hear a beep.
If you don't hear a beep after 7 or 8 seconds let go.
It should stay looking dead for a couple seconds while it resets.
This is best done with a small screwdriver - fingernails probably won't work for this process.
Related Articles
Insteon Hub Not Working - Red Light - Won't Connect
The Insteon Hub requires a cloud connection Insteon's servers in order to function. Unfortunately it appears that the Insteon Servers that power the Insteon Hub have gone offline. Without the cloud connection you are likely seeing a red light on ...
Insteon Warranty
At time of writing, we haven't had any communication whatsoever from Insteon, Smarthome or SmartLabs in some time but according to the smart home community it's likely that Insteon may have shut down. The Insteon Hub servers and Insteon Forums have ...
How to factory reset the Hubitat-C7 Z-wave hub
Be aware that factory/full resetting will do the following: "Zigbee and Z-Wave radios will be reset. All files on the hub will be deleted and if a restore from backup is attempted, Zigbee and Z-Wave devices will not work anymore without reset and ...
How to Reset/Reboot the First Alert SC5 Smoke & CO Alarm
In many cases, common problems like false alerts or communication issues can be fixed by factory resetting the First Alert SC5 Smoke and Carbon Monoxide Alarm. The steps below also explain how to remove an SC5 device from your First Alert account. ...
Factory Reset Inovelli VZM31 Blue Zigbee Switch
Many issues with initial installation or pairing can be resolved with a factory reset. To factory reset your Blue Series 2-1 Switch (VZM31-SN), hold down on the top of the paddle and the config / favorites button for 20 seconds until the LED Bar ...