Factory Reset SC1200

Factory Reset SC1200

Hold CLEAR until you see HOME CONTROL, then press 7 then 9 then ON then CLEAR.

This will reset the PIN to 0000, but retain all other settings.

    • Related Articles

    • How to factory reset the Hubitat-C7 Z-wave hub

      Be aware that factory/full resetting will do the following:  "Zigbee and Z-Wave radios will be reset. All files on the hub will be deleted and if a restore from backup is attempted, Zigbee and Z-Wave devices will not work anymore without reset and ...
    • Factory Reset DSC PC1616 / PC1832 / PC1864

      If you have lost or forgotten your installer code for Powerseries (PC1616/PC1832/PC1864) and need to make changes to the system programming you will need to factory reset the panel which will remove/reset ALL programming and should also reset the ...
    • Reset Hikvision Password

      If you are the owner of a Hikvision DVR or NVR and forgot your password, you will need to have your password reset, you can use this form for Canadian customers: https://www.hikvision.com/ca-en/support/password-reset/ You will also need to have ...
    • Factory Reset Insteon Switches

      Pull the set button out completely, let it stay out for 10 seconds. Push it back in PAST THE NORMAL POINT, all the way in and hold it for about 5 seconds or so until you hear a beep. If you don't hear a beep after 7 or 8 seconds let go. It should ...
    • Reset EVL-4

      There is a reset pad on the EVL4 near the PCLINK connector. Use a screwdriver or tweezers to short the pads for 5 seconds or until it reboots.