Homeseer WX300 Support in Hubitat
While the WX300 switch/dimmer from Homeseer should "work" out of the box as a generic device, in order to take advantage of more features a driver will be required. At time of writing, there is a community driver now available:
This is community written and community supported.
Related Articles
How to factory reset the Hubitat-C7 Z-wave hub
Be aware that factory/full resetting will do the following: "Zigbee and Z-Wave radios will be reset. All files on the hub will be deleted and if a restore from backup is attempted, Zigbee and Z-Wave devices will not work anymore without reset and ...
Aeotec Smart Home Hub 2/Aeotec Smart Home Hub Firmware (0.59.8) Update
Aeotec will begin rolling out firmware version 0.59.8 starting December 8, 2025. The rollout will happen in phases over several weeks, so your hub may not be updated immediately. Once the update is downloaded, your hub will briefly go offline while ...
Remote Management of Door Lock Codes with Hubitat
Hubitat users can add or remove PIN codes for door locks using the web interface. For remote management of lock codes, we recommend the optional (paid) Remote Admin Service. Advanced users may wish to set up a vpn for remote access to their Hubitat ...
Aeotec Smart Home Hub 2/Aeotec Smart Home Hub Firmware (0.60.12) Update
Aeotec will begin rolling out firmware version 0.60.12 starting on March 25, 2026. The rollout will happen in phases over several weeks, so your hub may not be updated immediately. Once the update is downloaded, your hub will briefly go offline while ...
eisy Lite vs eisy Home R2 - Comparison Guide
Both the eisy Lite and eisy Home R2 run the same IoX platform, use the same eisy UI, and support the full plugin catalog. The main difference between the two comes down to system capacity and budget. The eisy Lite brings the full eisy experience back ...