Reset EVL-4

Reset EVL-4

There is a reset pad on the EVL4 near the PCLINK connector. Use a screwdriver or tweezers to short the pads for 5 seconds or until it reboots.

    • Related Articles

    • Factory Reset SC1200

      Hold CLEAR until you see HOME CONTROL, then press 7 then 9 then ON then CLEAR. This will reset the PIN to 0000, but retain all other settings.
    • Reset PK5500/PK5501 and RFK5500/RFK5501 Keypad

      In case you accidentally program the partition or other settings incorrectly in the keypad or you're having trouble getting wireless to work in an RFK series keypad, you can reset the keypad following this procedure: *8 [INSTALLER CODE] 999 *  
    • Factory Reset DSC PC1616 / PC1832 / PC1864

      If you have lost or forgotten your installer code for Powerseries (PC1616/PC1832/PC1864) and need to make changes to the system programming you will need to factory reset the panel which will remove/reset ALL programming and should also reset the ...
    • Factory Reset Insteon Switches

      Pull the set button out completely, let it stay out for 10 seconds. Push it back in PAST THE NORMAL POINT, all the way in and hold it for about 5 seconds or so until you hear a beep. If you don't hear a beep after 7 or 8 seconds let go. It should ...
    • Envisalink EVL-3 and EVL-4 Programming for Honeywell Vista Systems

      Vista-10P/15P/20P/21IP Programming It is important that you create your EyezOn account and activate the module on the account before you connect it to the panel.   Overview   The EnvisaLink module will self-configure to work with the Vista panel once ...