TH135-1 Relay Always Closed

• Related Articles

• Connect a Siren Strobe or Strike to a Relay and Power Supply

  If you need to trigger a siren, strobe, or other device using a relay, you'll need to provide a power supply with enough capacity to run the siren and ensure you have a relay rated with sufficient capacity. The relay may be built into some other ...

• Wiring RC840T-120 Relay

  The Aube / Honeywell RC840T-120 relay provides two functions: Provide 24VAC power on the C and W terminals to power a low voltage thermosat Switch the 120V circuit when triggered by the low voltage R & W terminals Take care to ensure you are not ...

• Do Alarm Systems Require Normally Open Or Normally Closed Sensors

  Alarm systems are designed to use 'open loop' burglary sensors.  While they are called 'open loop', they are actually 'normally closed' when the magnet is near the sensor or in other words the zone is 'safe.  Motion, glass break and other burglary ...

• DSC Powerseries PC1616/PC1832/PC1864 EOL Resistors vs Closed Loop Programming

  By default, DSC Powerseries wired panels are expecting each zone to have EOL resistors installed.  If you are not going to use EOL resitors, you will need to turn Section 013 Option 1 to ON otherwise your zones will show open.  After you exit ...

• Connect 120V wired smoke detectors to security alarm system like DSC, Vista, Concord

  We are often asked how to add 120V wired smoke detectors to a low voltage security alarm system like DSC, Vista, Concord or Elk. First we need to point out that smoke detectors are a life safety product and so it's critical that you read and ...