EVL4 Stuck In Boot Loop

EVL4 Stuck In Boot Loop

There is a specific firmware version of EVL4 that can cause a boot loop *IF* the card is set for a static IP *and* has not yet connected to the eyezon portal for a firmware update.  It is always best to register the card on the Eyezon portal so it can receive the most recent firmware first.

In case of a boot loop, please try to factory reset the card then register it on the eyeon portal and wait a couple hours for a firmware update. 

There is a reset pad on the EVL4 near the PCLINK connector. Use a screwdriver or tweezers to short the pads for 5 seconds or until it reboots.

    • Related Articles

    • Connect2Go Dealer Supervision of UNO or EVL

      Connect2Go supervises UNO and EVL and will generate a report to the dealer automatically indicating unit(s) that go offline for a period of time. Additionally if the end user has alerts set up for supervision in their app, they will also receive ...

    • Uniview Waterproof RJ45 Boot and Installation Instructions for Outdoor Exposed Installations

      Uniview outdoor rated IP cameras come with a waterproof "boot" in the box. If the cable connection is exposed rather than enclosed in a sealed junction box or in the wall, this boot must be installed correctly to ensure water cannot infiltrate the ...

    • New Qolsys IQ4 Panel Won't Boot - Battery Issue - Troubleshooting

      Qolsys has identified a batch(es) of IQ4 panels that may have discharged or severely discharged, or bad batteries. If the new IQ4 panel won't boot initially please see the attached technical service bulletin on troubleshooting steps. FIRST TRY: Check ...

    • Reset EVL-4

      There is a reset pad on the EVL4 near the PCLINK connector. Use a screwdriver or tweezers to short the pads for 5 seconds or until it reboots.

    • Envisalink EVL-3 and EVL-4 Programming for Honeywell Vista Systems

      Vista-10P/15P/20P/21IP Programming It is important that you create your EyezOn account and activate the module on the account before you connect it to the panel.   Overview   The EnvisaLink module will self-configure to work with the Vista panel once ...