Reset PK5500/PK5501 and RFK5500/RFK5501 Keypad

Reset PK5500/PK5501 and RFK5500/RFK5501 Keypad

In case you accidentally program the partition or other settings incorrectly in the keypad or you're having trouble getting wireless to work in an RFK series keypad, you can reset the keypad following this procedure:

*8 [INSTALLER CODE] 999 *

 

    • Related Articles

    • Reset Hikvision Password

      If you are the owner of a Hikvision DVR or NVR and forgot your password, you will need to have your password reset, you can use this form for Canadian customers: https://www.hikvision.com/ca-en/support/password-reset/ You will also need to have ...
    • How to factory reset the Hubitat-C7 Z-wave hub

      Be aware that factory/full resetting will do the following:  "Zigbee and Z-Wave radios will be reset. All files on the hub will be deleted and if a restore from backup is attempted, Zigbee and Z-Wave devices will not work anymore without reset and ...
    • Enrolling Wireless Sensors on DSC Systems Using RFK5501 Keypad

      How to enroll wireless devices into a DSC alarm system using a PK5501 or RFK5501 keypad by manually entering the device ESN. Enter [ ✱ ][8][Installer Code][804].   01 for Zone 1 02 Zone 2 and so on Enter in 6 digit ESN number then hit # twice Enter ...
    • Factory Reset SC1200

      Hold CLEAR until you see HOME CONTROL, then press 7 then 9 then ON then CLEAR. This will reset the PIN to 0000, but retain all other settings.
    • Reset EVL-4

      There is a reset pad on the EVL4 near the PCLINK connector. Use a screwdriver or tweezers to short the pads for 5 seconds or until it reboots.