Setting Up Visonic PowerLinc Camera

Setting Up Visonic PowerLinc Camera

Please follow the following steps to configure your power link with any of the Visonic IP Cameras.

Visionic Powerlink Setup & IP cam

 The IP cam virtually had no setup required. Once you have the Powerlink working and setup correctly, as soon as you log in you should see your IP cams in the interface already.

Setting up Powerlink

1. Got to Windows Start Menu

2. Click on Run

3. Type CMD – Hit Enter

4. Type “Ipconfig”

5. Take note of the default gateway IP Address.

6. Open a new internet browser page.

7. Type the first three fields of the default gate way IP Address into the URL followed by  < .200  >  (do not include the < > )

a. For Example:

 

 i. Default Gateway : 192.168.0.1 or 192.168.1.1 or 192.168.2.1 (Use the first three fields of whatever your gateway is)

 ii. Replace the last field/digit with .200

 iii. End result = 192.168.0.200

 

8. You should now see the Powerlink interface.

9. Default Username & Password:

      a. Admin
b. Admin123

 Troubleshooting Tips

 1. Ensure you have your cat5 network cable connected from the powerlink to your router PRIOR to power the unit up, that also goes for the IP camera you are trying to connect. Must connect hardwired first, then you have the option to change to wifi in the settings.

 

    • Related Articles

    • Foscam IP Camera Search Tool for Windows and Mac

      See attached files for the Foscam IP Camera Search Tool for Windows and Mac.  Once the zip is downloaded, unzip it to extract the tool. See our retail Foscam Cameras and our Foscam Wholesale Distributor pages for products.

    • Setting Up Foscam Camera Remote Access On Bell 2Wire Modem

      Quick-Guide To Setting Up Foscam Cameras For Remote Access On Bell 2Wire Modem (Port Forwarding) By default, your Bell router will be located at IP address 192.168.2.1 Open a web browser and type in 192.168.2.1 and click go When you get to the router ...

    • Visonic MCT-102

      Visonic has discontinued their very popular remotes MCT-101, MCT-102, MCT-104 There is no direct replacement. You would need to purchase the new version MCT-101, MCT-102 or MCT-104 and also a new receiver MCR-304 or MCR-308 as well. The old remote(s) ...

    • Foscam Camera Set Up Guides

      For documentation on how to set up your Foscam camera for wired or wireless connectivity, port forwarding, dyndns, as well as their IP Camera finder tool and updated firmware, please visit: http://foscam.us/tools-support.html

    • Univew IP Camera Default Address

      By default, Uniview cameras ship with IP address 192.168.1.13 By default, when a Uniview camera is connected to a Uniview NVR PoE port, the plug and play set up will assign an IP in the range of 172.168.0.x