Programming Zone Labels on PowerSeries with IT100 Connected

Programming Zone Labels on PowerSeries with IT100 Connected

If you install a DSC IT100 and cannot program zone labels on PowerSeries, disconnect the IT100 from the panel and try again.  It may not allow zone label programming while the IT100 is connected.

    • Related Articles

    • Quick Guide For Programming DSC Powerseries Alarms

      Quick Guide To Programming DSC Powerseries Alarm Panels The following guide outlines the basic programming required when installing a DSC Powerseries Alarm System. This is a very short version designed to get most alarms up and running quickly.  For ...
    • Programming Zone Labels on DSC PK5500 Alpha Keypads

      The programming instructions for labelling zones on a PK5500 keypad are found in the keypad manual (not the main installation manual). They are a bit vague, so to summarize the sequence would be:   *8 Installer's Code * 001  (for zone one, 002 for ...
    • DSC Powerseries PC1616/PC1832/PC1864 EOL Resistors vs Closed Loop Programming

      By default, DSC Powerseries wired panels are expecting each zone to have EOL resistors installed.  If you are not going to use EOL resitors, you will need to turn Section 013 Option 1 to ON otherwise your zones will show open.  After you exit ...
    • Programming EZFLORA / Using EZFLORA with ISY99 or ISY994

      EZFLORA can be controlled by an automation controller like the ISY99 or ISY994 series. The controller would dictate schedules to turn the zones off and on, and normally no additional configuration of the EZFLORA is required.   In some unique ...
    • Procedure for converting DSC 6 digit serial numbers to 5 digit serial numbers

      The 1st digit of ESN number is also 1st digit of SN Open up calculator in Microsoft Windows Click on VIEW at top of calculator and select SCIENTIFIC (or PROGRAMMING in Vista or Win 7 Click on HEX button at top left of calculator Input the 2nd, 3rd ...