Adding More Than 8 Cameras to Uniview NV202-16

Adding More Than 8 Cameras to Uniview NV202-16

The Uniview NV202-16 has 8 POE ports built in for directly connecting Uniview POE cameras.  However if more than 8 cameras are connected, see the attached guide for the simplest method which maintains a private LAN for the cameras and NVR. The single NVR port in this case connects to the customer network to provide remote/internet access.

    • Related Articles

    • Uniview UNV Control4 Integration Driver

      There is a Control4 driver for Uniview / UNV cameras and NVRs available from this developer: https://chowmain.software/drivers/control4-uniview It allows integration with cameras on the network (probably best) or with cameras connected to the NVR.

    • Adding Uniview Encoder

      Uniview NVRs can accept analog cameras by using a Uniview hardware encoder that converts the analog camera feed to an IP feed.  The attached document explains how to set up the Uniview encoder.

    • NDAA Compliant Security Cameras and NVRs

      NDAA as it refers to security cameras, NVRs and telecommunication equipment refers to the American National Defense Authorization Act law that was passed for the 2019 budget to block only United States federal government organizations like the ...

    • Adding Cameras to NV208-32

      Since the NV208 does not have built in POE ports for each camera (there would be too many ports), the NV208 will connect to a POE enabled switch of sufficient size to connect the cameras and NVR.  Whereas smaller NVR models will auto configure the ...

    • Uniview Waterproof RJ45 Boot and Installation Instructions for Outdoor Exposed Installations

      Uniview outdoor rated IP cameras come with a waterproof "boot" in the box. If the cable connection is exposed rather than enclosed in a sealed junction box or in the wall, this boot must be installed correctly to ensure water cannot infiltrate the ...