Evolve LFM-20 Controlling 120V Load
The LFM-20 is powered by 120VAC (house voltage), and has an isolated relay. This means the 2 blue wires, the relay output, are not powered normally. They can be used to switch anything within the load rating from dry contact, to low voltage and up. Please note that if you are mixing low and high voltage, and with all 120V products you must ensure you are meeting all electrical and building codes and we recommend an electrician do the work.
When the LFM-20 is used to switch a light/load that is powered by the same source power (sharing hot & neutral), then the black & one blue can be bridged to provide 120V power on the 2nd blue when the LFM20 is triggered. See the attached diagram.
Please ensure you read and understand before proceeding and be sure to check this with an electrician. We will not be held responsible for any issues arising from the use of this diagram. Use at your own risk!
Related Articles
Evolve T100R Change To Heat Pump
System Operation – Fan Coil/PTAC vs. Heat Pump: The Evolve thermostat have two most commonly engaged modes: Fan Coil: This setting also pertains to PTAC operation, as it does not require the integration of a change-over (reversing) valve. Heat Pump: ...Simply Automated V-3Way Wiring and Troubleshooting
> - Do you have proper schematics when more than one pair of switches are installed? > - What exactly is the wire that is white with a brown stripe supposed to be for? > - Is the brown wire required on both switches of a pair in each room? These are ...Controlling X10 From 2412N SmartLinc
The 2412N SmartLinc was designed as a simple Insteon controller with some support for X10. It has basic manual control of X10 devices by using the X10 control page (click the wrench Icon, look for ‘Open X10 Controller’). It does not have a simple ...Foscam Plugins No Longer Load in Firefox and Chrome
Recent versions of both Firefox and Chrome no longer support NPAPI plug-ins which are what most manufacturers including Foscam use for live camera viewing. This is not a change made by Foscam but rather the web browser companies. We recommend using ...How to Add a DVR, NVR or IPC Camera to IVMS4200 Client Software
See this video: https://www.youtube.com/watch?v=l25my2EYlxQ