Controlling X10 From 2412N SmartLinc
The 2412N SmartLinc was designed as a simple Insteon controller with some support for X10. It has basic manual control of X10 devices by using the X10 control page (click the wrench Icon, look for ‘Open X10 Controller’). It does not have a simple way to schedule X10 events however you can use their ‘custom command’ section to accomplish this.
You can learn more about this using the wiki documentation:
2412N Wiki Documentation
In a nutshell:
Create a room, and then add a scene
Click on the scene
Click on ‘Click Here To Customize Controls’
For the ON or OFF line, check ‘custom command’ and then add your custom string to control your device(s).
Documentation on custom strings can be found here in the same WIKI manual above, or direct linked here:
2412N Wiki Custom Commands
Once you have the scene set up you can optionally create a timer on the scene.
Related Articles
SmartLinc 2412N Time
If you are finding that the SmartLinc 2412N is losing time or not keeping exact time, please refer to the following articles that users have submitted as a way around the issue as there is currently no support for an Internet time sync in this ...
X-10 or Insteon Devices Not Communicating
Powerline (eg. X10, Insteon, UPB) automation signals travel along the household power wiring. There are two main issues that can affect performance. One is that your house electrical system is split in to 2 phases at the breaker panel. The other ...
Evolve LFM-20 Controlling 120V Load
The LFM-20 is powered by 120VAC (house voltage), and has an isolated relay. This means the 2 blue wires, the relay output, are not powered normally. They can be used to switch anything within the load rating from dry contact, to low voltage and ...
Univew IP Camera Default Address
By default, Uniview cameras ship with IP address 192.168.1.13 By default, when a Uniview camera is connected to a Uniview NVR PoE port, the plug and play set up will assign an IP in the range of 172.168.0.x
2412N With Blackberry
While there is no official blackberry application for the 2412N, it is possible to access the 2412N using the Blackberry browser using the following procedure: 1. Log onto http://smartlinc.smarthome.com/. 2. Enter “hindex.htm” on the end of the ...