Average temperature reading on OMNIstat2

Average temperature reading on OMNIstat2

The average temp function will only work when you have either 1 or 4 units, it will not work if there are 2 units or 3 units. Also this function will only work for items 23A00-1 & 23A00-2

    • Related Articles

    • 2441TH Temperature Calibration

      Although the temperature readings from the factory are normally accurate, if you find your thermostat is not reading the correct ambient room temperature, please follow this guide or check the user manual. Make sure the hole in the wall through which ...
    • Remote Temperature Control and Monitoring

      I have a cottage and want to be able to turn up the heat when I'm en-route and turn it back down when I'm not at the cottage.  Most of our Aube thermostats support a phone controller option so you can call in, enter your password and turn the heat up ...
    • Aeotec ZW100 Temperature Reporting

      By default, ZW100 reports in F and the automation controller will convert to C if necessary.
    • Poor Range or Connection with 433 MHz Devices / Sensors

      Q: I Have Poor Limited Range or Connection with 433 MHz Devices like DSC Wireless Sensors? A: You may have an interference problem. More Information on 433 MHZ Wireless Devices In Canada, the 433 MHz frequency band is shared by many consumer and ...
    • Shelly Cloud Devices Control4 Drivers

      Control4 drivers are available for Shelly Cloud Gen 1 and Gen 2 / Plus devices via chowmainsoft on their web site: https://chowmain.software/drivers/control4-shelly-generic Driver Features Supports Huge Range of Shelly module functionality Native ...