Replacement for Visonic WR200, WR300, WT101, WT102, WT104
WR200 and WR300 receivers has been replaced by MCR-304 (1 channel) and MCR-308 (4 channel) receivers.
WT101, WT102, WT104 have been replaced by MCT-101, MCT-102, MCT-104 (1,2, 4 button) transmitters.
http://www.aartech.ca/visonic-wireless
The new and old units are NOT cross compatible so please be sure to replace both receiver and transmitter(s) at the same time. The new units are now with encryption for enhanced security.
Related Articles
Replacement for Visonic WT101, WT102, WT104, WR200
After over 10 years of supporting the older series, Visonic has discontinued the WT101, WT102, WT104 transmitters and WR200 receiver series. The new models are MCT-101, MCT-102, MCT-104. Unfortunately they use a new, encrypted signal so the older ...
Visonic MCT-102
Visonic has discontinued their very popular remotes MCT-101, MCT-102, MCT-104 There is no direct replacement. You would need to purchase the new version MCT-101, MCT-102 or MCT-104 and also a new receiver MCR-304 or MCR-308 as well. The old remote(s) ...
Defective COS2010 Replacement
> I have an old model American Sensors, I want to confirm that it is the > COS2010 and that the replacement is the SC9120BA acording to your link: > http://www.aartech.ca/page/cos2010-sa360 > Please refer to the following page: ...
Setting Up Visonic PowerLinc Camera
Please follow the following steps to configure your power link with any of the Visonic IP Cameras. Visionic Powerlink Setup & IP cam The IP cam virtually had no setup required. Once you have the Powerlink working and setup correctly, as soon as you ...
Dicon American Sensors SA360 Replacement
Dicon (American Sensors) SA360 has been discontinued with no direct wire replacement. You can replace your SA360 (in Canada) with 9120A or 9120BA from BRK which is made by the same factory and is cross listed as compatible.. You should replace all ...