Wireless PIR Motion Detector Testing and Operation
Wireless motion sensors from DSC, Elk, Honeywell, Resolution, etc are designed to trip once when they see motion and then go to 'sleep' for quite a while before waking up to detect motion again. This is to conserve battery. They also don't flash the LED once installed... So this sometimes causes trouble when trying to bench test their function and people think they may not be functioning properly.
The best way to bench test would be:
1) put the motion sensor in a drawer or somewhere that it's impossible to detect any motion.
2) leave it for 10 minutes .. give it time to reset
3) arm the alarm system to AWAY mode
4) make sure you open and then close an exit door (** important - or the system will fall back to stay mode which disables all motions)
5) go open the drawer and give the sensor motion
Related Articles
Wireless PIR Motion Detector Testing and Operation
Wireless motion sensors from DSC, Elk, Honeywell, Resolution, etc are designed to trip once when they see motion and then go to 'sleep' for quite a while before waking up to detect motion again. This is to conserve battery. They also don't flash ...
Wireless PIR Motion Detector Testing and Operation
Wireless motion sensors from DSC, Elk, Honeywell, Resolution, etc are designed to trip once when they see motion and then go to 'sleep' for quite a while before waking up to detect motion again. This is to conserve battery. They also don't flash ...
Wireless PIR Motion Detector Testing and Operation
Wireless motion sensors from DSC, Elk, Honeywell, Resolution, etc are designed to trip once when they see motion and then go to 'sleep' for quite a while before waking up to detect motion again. This is to conserve battery. They also don't flash ...
Adding Wireless to the E27 and When to Use the Bus Versions of the Wireless Cards
The AERF3 or AERF9 add wireless to the Elk Alarm Engine E27 panel. These wireless cards are available as bare cards that connect to the panel. Or as a bundle with a bus adapter. The Elk E27 Alarm Engine main panel can accept one RF Receiver directly, ...
Troubleshooting a Beeping or Chirping Smoke Detector or Carbon Monoxide Detector
If your smoke detector or carbon monoxide detector is sounding an alarm, you need to take action immediately to check for smoke or in the case of a carbon monoxide alarm clear the building and call the fire department to check for dangerous CO ...